| Step | | Procedure & Parts & Tools |
| 1 |
|
LIFT THE RECOVERY TANK FROM THE MACHINE AND CARRY TO DRAIN TO EMPTY. PUSH THE MACHINE OVER A DRAIN AND REMOVE THE YELLOW SOLUTION FILTER CAP TO DRAIN THE SOLUTION TANK.
|
| 2 |
|
RAISE THE TANK COVER UP UNTIL IT POPS OFF MACHINE.
|
| 3 |
|
LOCATE THE 2 HOSES COMING UP THRU THE SOLUTION TANK. PULL THE HOSE CUFFS OFF HOSES.
|
| 4 |
|
REMOVE THE 4 BOLTS HOLDING THE BATTERY COVER.
| Torx T30 |
|
|
| 5 |
|
SLIDE BOTH BATTERIES FROM THE BATTERY COMPARTMENT. NO NEED TO DISCONNECT THE CABLES.
|
| 6 |
|
REMOVE THE 2 BOLTS IN THE BATTERY COMPARTMENT.
| Torx T30 |
|
|
| 7 |
|
LOOSEN THE BOLT ON THE FRONT OF THE SOLUTION TANK.
| Torx T30 |
|
|
| 8 |
|
REMOVE THE 2 SOLUTION TANK BOLTS ON EACH SIDE OF THE TANK.
| Torx T30 |
|
|
| 9 |
|
RAISE THE SOLUTION TANK UP.
|
| 10 |
|
LOCATE THE CHECK VALVE.
|
| 11 |
|
PULL THE HOSE THAT RUNS FROM THE CHECK VALVE TO THE MANIFOLD. TURN THE POWER ON AND TURN THE SOLUTION ON.IF WATER RUNS OUT OF THE CHECK VALVE, THE CHECK VALVE IS OKAY. TURN OFF THE SOLUTION.
|
| 12 |
|
IF THE CHECK VALVE IS OKAY, REVERSE STEPS 1 THRU 11 TO REASSEMBLE THE MACHINE.
|